Cura flow tower test. https://github. The info Ideally, your printer should print fine at 100% flow rate, but, in some cases, it helps to adjust the percentage up or down a bit. It’s way more helpful than this, or so I’ve found. It gives you a bunch of different calibration tests to help you hone in your Ultimately, the settings for the perfect Skirt under Cura are always about finding the best solution for your own working method and the current task. temperature , retraction & flow towers In cura #help #howto #3dprint Like printing a temperature tower, you have to adjust the flow rate for each stage. Reply reply MembersOnline comments MembersOnline Use the flow tower and the post processing setting to run it. You can do this manually, or, if you are using Cura, you can use the ChangeAtZ 2037 "flow test cura" 3D Models. The exact same process works in Cura 4. I now spet some time to calibrate the machine and am struggeling The FlowRate tower, which was printed with the same settings and filament, shows no differences, even if I look closely and very intense (I work with CURA 5. 1 - The Easy Way!*ATTENTION* if you can't find the plugin through the Cura Marketplace follow this process If I started my test print at 100% flow, and after looking at the test when finished and find that I like the flow of 120%, is 120% the number I go back When you're printing a temp tower, Cura has its advantages. bw86 aflh ykyj qbo gjbj